Calibrator brings calibration to your plant. Metrologists arrive with calibration kits, work through an agreed instrument list, and leave you a certificate for every device.
This page explains how a calibration visit runs from first contact to certificates. Instrument-specific methods are on the service pages linked below.
1. Agree the scope
Every visit starts from an instrument list. For each device we need its tag, its measuring range, the calibration points to check, and the tolerance it must meet. Tolerances come from your process requirements; for transmitters without a process-specific value, the manufacturer's tolerance is used. The list can be reviewed again at each visit.
2. Plan the visit
Visit dates are agreed with your team in advance. Ahead of each visit we contact you to confirm the plan, check which areas and instruments will be available, and adjust the schedule if anything has changed. Visits can be single missions or a recurring program.
3. Calibrate on site
Metrologists work through the list with portable reference equipment. Where possible, calibration is done as a loop: a known reference value is applied at the sensor and the reading is checked on the main display. If the signal is shown on more than one display, all of the indications are checked. Methods by instrument type:
- Temperature and pressure instruments: compared against reference equipment at several points across the range.
- Conductivity and pH meters: compared against NIST-traceable standard solutions.
- Flow meters: checked in place against a clamp-on ultrasonic flow meter.
- Rotational speed devices and tachometers.
4. Share findings during the work
We keep in contact with your team throughout the visit, so out-of-tolerance findings are known while the team is still on site.
5. Certificates for every instrument
When the visit is complete, you receive a calibration certificate for each instrument. Every certificate includes a table with the calibration results, the error of the device, and the uncertainty of the measurement. Certificates are delivered electronically and signed by the calibration specialist who did the work.
Common questions
What do you need from us before a visit?
An instrument list with tags, measuring ranges, the calibration points you want checked, and the tolerance for each device. Where you have no process-specific tolerance, the manufacturer's tolerance is used for transmitters.
Do you calibrate the instrument alone or the whole loop?
Where possible, calibration is done as a loop: the reference value is applied at the sensor and the indication is read on the main display. If the signal appears on more than one display, every indication is checked.
What do we receive after the visit?
A calibration certificate for each instrument, delivered electronically and signed by the calibration specialist. Each certificate has a table with the calibration results, the error of the device, and the uncertainty of the measurement.
Can calibration be set up as a recurring program?
Yes. Visits can be planned as single missions or as a recurring program, with dates agreed with your team in advance.
Related pages
- Temperature and pressure
- Conductivity and pH
- Flow meter verification
- Rotational speed and tachometers
- Calibrator home
Contact
Send your instrument list or questions to contact@calibrator.tech or call +1 (407) 721-1750.
You can also use Get a quote to send a calibration request.
Calibrator LLC
850 E Lime St, P.O. Box 1057
Tarpon Springs, FL 34689
